示波器型号是安捷伦3034,在3000X-Series Oscilloscope这本编程指南中例如P430中提到的:MEASure:OVERshoot测量过冲,在输入这句语句以后不知何原因一直测量
2015-07-04 22:24
示波器型号是安捷伦3034,在3000X-Series Oscilloscope这本编程指南中例如P430中提到的:MEASure:OVERshoot测量过冲,在输入这句语句以后不知何原因一直测量
2015-07-05 12:51
Overshoot and Undershoot Specification for MB9BF116R. Especially, about the below pins-Address Pin-Data Pin-GPIO Pin Best Regards,Inoue
2018-08-17 00:57
?以上来自于谷歌翻译以下为原文Say I have overshoot (both positive and negative)beyond 1V at the input of my digital
2019-01-25 10:55
the ADC value to avoid overshoot.it is happening as i read the ADC and give command to power circuit
2018-09-28 11:01
me know the voltage specifications that pin types allow for overshoot / undershoot of SCB / GPIO input voltage. Best Regards,Naoaki Morimoto
2018-10-22 09:59
period. I use speed control, and thecontroller have a serious overshoot and a very long setting
2019-01-09 15:29
(to ensure a correct behaviour during configuration), but It leads to a strong overshoot
2019-06-11 14:54
clock to P1(4). Square, fed thru 100 ohm to minimize overshoot, which is 800 mV. The adjacent pins, P1(2
2019-04-28 07:35
dq bus in ucf, and find there is overshoot on the signal, which may be the cause of my board
2019-07-15 09:52