示波器型号是安捷伦3034，在3000X-Series Oscilloscope这本编程指南中例如P430中提到的:MEASure:OVERshoot测量过冲，在输入这句语句以后不知何原因一直测量
2015-07-05 12:51
示波器型号是安捷伦3034，在3000X-Series Oscilloscope这本编程指南中例如P430中提到的:MEASure:OVERshoot测量过冲，在输入这句语句以后不知何原因一直测量
2015-07-04 22:24
the ADC value to avoid overshoot.it is happening as i read the ADC and give command to power circuit
2018-09-28 11:01
：目前建议上升沿时间小于200ns5、不要有overshoot and ringing二、以下是标准的波形：三、如果波形有以下现象，不符合要求，需要调整1、三角波，上升沿和下降沿时间不符合要求2、有overshoot and ring..
2022-01-18 10:13
at 2.5 Amps continuous. The output follows the input during overshoot.
2018-07-23 06:04
？以上来自于谷歌翻译以下为原文Say I have overshoot (both positive and negative)beyond 1V at the input of my digital
2019-01-25 10:55
(to ensure a correct behaviour during configuration), but It leads to a strong overshoot
2019-06-11 14:54
Overshoot and Undershoot Specification for MB9BF116R. Especially, about the below pins-Address Pin-Data Pin-GPIO Pin Best Regards,Inoue
2018-08-17 00:57
me know the voltage specifications that pin types allow for overshoot / undershoot of SCB / GPIO input voltage. Best Regards,Naoaki Morimoto
2018-10-22 09:59
ringing and overshoot during transmission thandigital waveforms do.
2009-05-12 11:00
