• 发文章

  • 发资料

  • 发帖

  • 提问

  • 发视频

创作活动
0
登录后你可以
  • 下载海量资料
  • 学习在线课程
  • 观看技术视频
  • 写文章/发帖/加入社区
返回

电子发烧友 电子发烧友

  • 全文搜索
    • 全文搜索
    • 标题搜索
  • 全部时间
    • 全部时间
    • 1小时内
    • 1天内
    • 1周内
    • 1个月内
  • 默认排序
    • 默认排序
    • 按时间排序
  • 全部板块
    • 全部板块
大家还在搜
  • 使用STM32_Programmer_CLI连接端口出现超时错误怎么解决?

    while waiting for acknowledgement.Timeout error occured while waiting for acknowledgement

    2023-01-05 08:16

  • 怎么使用BLE USB Dongle查询文件传输

    me acknowledgement after receiving a packet. if response is Pass i need to continue with further

    2019-06-28 15:58

  • LSM9DS0传感器未给出确认

    have done below approaches but not getting any acknowledgement. 1. Change pull resistor from 10K

    2018-10-23 16:56

  • 求助一个I2C问题

    == 1) { /* Disable Acknowledgement */I2C_AcknowledgeConfig(I2Cx, DISABLE);/* Send STOP Condition

    2014-09-05 15:22

  • 启动LIS331DLH加速度计没有得到确认

    am going to set the config register 1i am not getting acknowledgement, what may be the cause?#lis331dlh

    2018-09-29 11:09

  • NRD24L01 NRF24L01_TxPacket一直返回1E的原因是什么

    NRD24L01 NRF24L01_TxPacket一直返回1E的原因是什么

    2021-12-17 07:18

  • CY7C68013A停止向FPGA传输数据

    acknowledgement of my last transmitted packet. I have attached signals received on chipscope. Please

    2019-05-23 13:40

  • MRF24J40无法同时获得多个RX

    你好,我用的是MRF24J40,它是一个带有1个PAN协调器和1到8个连接设备的星形盘。PAN协调器运行Linux,并用C++编写。该设备在C中实现智能化,PAN协调器与设备之间的通信工作良好。当2个设备同时向PAN协调器发送帧时,仍然存在一个问题。PAN协调器在那时接收OR 1帧。有没有办法处理INTGPIO来处理多个RX?谢谢) 以上来自于百度翻译 以下为原文 Hi, I'm using the MRF24J40 for a star PAN with 1 PAN Coordinator and 1 to 8 connected devices. The PAN Coordinator runs Linux and is written in C++. The devices are witten in C. The communication between the PAN Coordinator and the devices works fine. There is still an issue when 2 devices send a frame to the PAN Coordinator at the same time. The PAN Coordinator receives ony 1 frame at the time. Is there a way to handle the INT GPIO to handle multiple RX ? Thanks :)

    2019-04-22 12:59

  • BM78流量控制问题

    pattern. It might work better to send data as a command and wait for acknowledgement. In that case

    2019-05-14 08:19

  • ARM系列 -- 存储模型(二)

    Acknowledgement。在ARM的体系结构中,对于处理器的写操作,需要存储器的端点(endpoint)发出一个确认(acknowledgement)才能认为写操作完成。如果存储区域具有E属性,那么处理器写的内容缓存在某些

    2022-04-11 15:46