在使用cubeprogrammer烧录时(基于UART的),报错Timeout error occured while waiting for acknowledgement.是什么原因导致的呢?
2024-03-25 06:58
while waiting for acknowledgement.Timeout error occured while waiting for acknowledgement
2023-01-05 08:16
am going to set the config register 1i am not getting acknowledgement, what may be the cause?#lis331dlh
2018-09-29 11:09
) Completion acknowledgement (用于 RN request 和其它 RN snoop 之间保序) Transaction ordering (用于 RN 和 HN 之间保序)
2022-04-06 11:17
me acknowledgement after receiving a packet. if response is Pass i need to continue with further
2019-06-28 15:58
have done below approaches but not getting any acknowledgement. 1. Change pull resistor from 10K
2018-10-23 16:56
== 1) { /* Disable Acknowledgement */I2C_AcknowledgeConfig(I2Cx, DISABLE);/* Send STOP Condition
2014-09-05 15:22
failure, did not receive command acknowledgement in response to '#' device query command before
2019-06-12 07:06
:synchronous建立联机。ACK:acknowledgement 确认。PSH:push传送。FIN:finish结束。RST:reset重置。URG:urgent紧急。
2022-03-23 10:12
pattern. It might work better to send data as a command and wait for acknowledgement. In that case
2019-05-14 08:19