->LCD_REG = R34; /* Select GRAM Reg *//* Read 16-bit Reg */dummy =
2014-10-15 17:07
-----------------------------------------------------------*/typedef struct{vu16 LCD_REG;vu16 LCD_RAM;} LCD
2018-11-22 09:50
;//r:1'b1w:1'b0wire di_select;//d:1'b1i:1'b0;wire w_start;wire [7:0]w_data;lcd_ctrl U2(.clk(clk_1M
2019-07-18 09:52
_Writ_Bus(da);} void LCD_WR_REG(char da) {LCD_DC=0;LCD_Writ_Bus(da);}void LCD_WR_REG
2015-04-04 19:55
（）调试打印信息，却导致ucgui对LCD初始化不成功，不屏蔽是正常的void LCD_WriteReg(u8 LCD_Reg, u16 LCD_RegValue){1
2014-04-24 21:52
_rw;output lcd_en;output [7:0]lcd_data;reg clk_lcd;reg
2014-09-12 15:23
{:4_97:}module lcd1602(rst,clk,rw,rs,d,e);input clk,rst;output rs,rw,e;output [7:0]d;reg rs,rw,e;//reg[7
2014-04-28 23:24
，） GPIO_SetBits(GPIOE, GPIO_Pin_1 );//上电开启Delay(0xAFFF);//再来一次第二步，当然是PLL设置啦。代码如下：LCD_WR_REG(0x00E2);//0XE2是设置
2019-10-14 09:11
LCD_RST: NRST 现在我这边配置的地址： 红色的部分对不对？？ #define LCD_REG*(vu8*)(((u32)0x60000000)) #define LCD_RAM*(vu8
2024-04-10 08:02
en;output [7:0] data;output rs;output rw;output p***;reg rs;reg [7:0] data;reg lcd_
2019-03-11 06:35
