Good evening everybody. I know this has been asked a milion of times, but I checked all the ansers
2018-12-11 15:46
我用PICTIT3编程了一个16F87A的UART。所有的工作都很好，直到我断开了微芯片和程序员之间的通信电缆。在UART上不再有通信。似乎UART已经死了，直到我再次连接皮卡，al工作得很好。 以上来自于百度翻译 以下为原文I programmed the UART of a 16f877a with pickit3. All works well till I disconnect the communication cable between the microchip and the programmer. There is no communication anymore over the UART. It seems the UART is dead till I connect the pickit again, al works fine then.
2019-01-03 14:42
