已经完成了引脚输出的ucf文件，但是当我尝试配置目标，并且lauches inpact for me时，我无法检测到电缆在所有当我做自动边界扫描如下 ：// *** BATCH CMD：setMode
2019-05-13 08:35
您好，测试8482B功率传感器的推荐水平是多少？是否使用固定衰减器测试传感器是否受到传感器攻击？如果我使用8482A传感器作为此测量的参考，则传感器的电平约为10 dBm存在影响校准因子计算的漂移。 （我使用2 X 8482A，在测试设置中通道功率计和功率分配器，即我的发生器的电平高6 dB）传感器本身有一个黑色塑料保护环，禁止它连接正常N - 连接器因此单独测试传感器并分别测量衰减器的衰减并不容易，然后计算校准因子。该怎么办？坦克任何建议！ 以上来自于谷歌翻译 以下为原文Hello,What is the recommended level for testing the 8482B power sensor?Is the sensor tested with or without the fixed attenuator attacked to the sensor?If I use an 8482A sensor for reference for this measurement and a level of about 10 dBm into the sensor there is an drift that influence on the calculation of the calibration factors. (I use 2 X 8482A, to channel power meter anda power splitter in the test setup, i.e the level from my generator is then 6 dB higher)The sensor itself has an black plastic protection ring that prohibits it from connect on an normal N-connector so it's not that easy to test the sensor alone and measure the attenuation of the attenuator separate, for then compute the calibration factors. What to do?Tanks for any advice!
2019-07-11 15:48
