嗨，我已经在ISE 14.7中的芯片内窥镜IBERT核心上生成了以太网10G BASE-R核心，我能够成功运行眼睛扫描测试。在IBERT GUI中，如果我将DWELL BER设置为1e-5是什么意思？以及如何转换为ES_PRESCALE值？谢谢钱德拉
2020-08-17 09:13
){GPIOB->PUPDR &= ~(3ARR = 0xFFFF;//250; // 最大计数TIM3->CCMR1 = 1; // 比较 1TIM3->DIER = (1SR &= ~1;}}Dwell不会前进，除非我把Dwell
2022-12-02 06:44
have it setup for it to dwell at each frequency for 5ms. When I look at the signal though the dwell
2019-07-02 07:51
and the third is the dwell time. I don't want to load a list from a file, but rather make a list
2019-03-14 10:14
:_ In the bar graph, how to set the dwell time to 1 or 2 seconds to measure quasi peak.
2019-08-09 14:19
for 10.5ms LIST:DWEL 10, 0.0105 LIST:STEP AUTOList to be paced by Dwell time TRIG:SOUR BUSGPIB
2019-05-20 14:16
Hopping Channel Number 限值：≥15 channels7、 驻留时间Dwell Time 限值：＜0.4s8、边带Band Edge9、天线要求Antenna Requirement
2021-04-16 10:17
replacement unit).Basically the setup is just the following commandsThe frequency, power, and dwell lists
2019-07-16 11:45
;01_004C_0820_0000_0000"; ---Enable SYNC_CLK and DRG, no-dwell HIGH--constant CFR2_DRG_OFF:std_logic_vector(71 downto 0
2013-07-11 23:17
is assigned a maximum temperature and dwell time. The tabulated levels are the maximum temperature
2017-11-02 14:30
