co-ordinator (inter mediate co-ordinator) which is getting short address of 0x0100 then switched on end
2019-07-29 16:34
你好 我试图从LIS3DSH以高速率获取连续数据，并且数据中存在不连续性 - 任何输入/建议/反馈都将非常受欢迎。 目标是1600 S / s的全速率，但800 S / s就可以了。只需要一个通道（Y似乎是最低噪声）。传感器通过I2C总线以400 kHz进行通信。已经尝试过FIFO和直接读取。 - 400 kHz I2C总线上的合理最大数据速率是多少？- 是否可以使用FIFO并只读取单个通道？- 数据中不连续性的最可能原因是什么 - 这些与缓冲区中的大量元素之间似乎微弱相关，但没有证据表明我们接近最多32个元素 - 见附图 谢谢！ 亚伦 #odr #fifo＃lis3dh #accelerometer以上来自于谷歌翻译以下为原文 Hello I'm attempting to acquire continuous data at high rate from a LIS3DSH, and getting discontinuities in the data - any input / suggestions / feedback would be hugely appreciated. The aim is full rate of 1600 S/s, but 800 S/s would be OK.Only one channel is required (Y seems to be lowest noise).The sensor is being communicated with over an I2C bus at 400 kHz.Both FIFO and direct reading has been tried. - What is a sensible maximum data rate on a 400 kHz I2C bus? - Is it possible to use the FIFO and read only a single channel? - What is the most likely cause of discontinuities in the data - these seem weakly correlated with a larger number of elements in the buffer, but there is no evidence we are getting anywhere near the maximum 32 elements - see attached image Thanks! Aaron #odr #fifo #lis3dh #accelerometer
2019-05-17 16:17
