Transient time point calculation did not converge Simulation canceled See convergence help for more information
2015-07-07 21:06
来自于谷歌翻译 以下为原文Convergence errors occur in a simulation with an EM model in harmonic balance
2018-10-12 17:16
如上图，环境是orcad 9.2/ capture仿真时报错：ERROR -- Convergence problem in transient bias point calculation
2020-06-16 10:58
point calculation did not convergeSimulation canceledSee convergence help for more information遇到这种问题应该怎样解决？
2014-03-04 16:31
用protuse仿真出现iterations without convergence，什么意思怎么解决?求高手指点
2013-04-20 15:56
我用这个软件不久，每次画图器件比较多时，仿真就会出现：A simulation error has occurred.Would you like to run the Convergence
2012-11-28 17:08
A simulation error has occurred. Would you like to run the Convergence Assistant to attempt
2013-02-27 10:53
A simulation error has occurred.Would you like to run the Convergence Assistant to attempt
2017-08-26 12:25
to proceed to the next sweep point after a convergence failure?The simulation currently stops after any
2019-05-21 12:48
in the library is written to give sampling rate of 10Hz. The convergence time is set as 30ms for Ranging
2019-05-17 09:43
