positioning of programmable> semiautomatic analytical wafer probers manufactured by Wentworth.>
2019-09-09 08:44
be set properly, is there any concete example of the analytical steps someone should take to set
2019-01-15 10:21
根据帮助菜单，ET为-16dBc。现场工程师表示-20dBc，然后我恢复了-23 dBc的设置。什么是适当的ET水平，如果与最佳水平不同，有什么警告？谢谢 以上来自于谷歌翻译 以下为原文According to the Help menus, ET is -16dBc. A field engineer stated that -20dBc, and then I got back a setting for -23 dBc. What is the proper ET level, and if different from optimal, what are the caveats? Thanks
2018-12-25 16:19
嗨，在网络实施期间，当我将用户ILA端口从3个端口扩展到11个端口时，会生成以下消息：[Vivado_Tcl 4-131] Power Optimization遇到异常：ERROR：[Common 17-70] Application Exception：！（flpInst-> getEnable（ClSynOptions :: IDT_QUI）！=“F”＆amp;＆amp; enBDD == pwroptMgr-> getCurrentBddMgr（） - > bddZero（））[Vivado_Tcl 4-130] Power Optimization遇到错误。感谢您的帮助或解决方案......问候以上来自于谷歌翻译以下为原文Hi,During a networking implementation, when i extend user ILA ports from 3 to 11 ports, below messages has been generated: [Vivado_Tcl 4-131] Power Optimization encountered an exception: ERROR: [Common 17-70] Application Exception: !(flpInst->getEnable(ClSynOptions::IDT_QUI) != "F" && enBDD == pwroptMgr->getCurrentBddMgr()->bddZero()) [Vivado_Tcl 4-130] Power Optimization encountered an error. Thanks for any help or solution...Regards
2018-11-08 11:29
大家好，芯片是PIC18F46K22，我用XC8编译器。我用上面的20MHz石英晶体的PIC，在一个应用中，在这个UART端口上连接了一个指纹设备和一个GSM调制解调器。20兆赫的情况很好，但由于这个PIC可以达到64兆赫，我很好奇，知道什么是有利和不利因素，以更高的晶体频率。非常感谢你的帮助。 以上来自于百度翻译 以下为原文 Hello everyone My chip is PIC18F46K22, and I am using XC8 compiler. I am using the above PIC with 20MHz quartz crystal in an application where a finger print device and a gsm modem are connected on this chip on its UART ports. The 20MHz is doing fine but as this PIC can go upto 64MHz i was curious to know what could be pros and cons of going to higher crystal freq. ? Your help is highly appreciated.
2018-11-05 14:56
本文以液晶显示器技术为主轴，谈谈平面显示器的技术发展与实验室中的研究方向。
2021-06-07 07:01
量子是什么？各种量子技术都是啥？量子计算机有啥用？怎么做？
2021-10-14 06:40
