Multisim仿真提示：======= SPICE Netlist check completed, 0 error(s), 0 warning(s) ======= Transient time
2014-03-04 16:31
Transient time point calculation did not converge Simulation canceled See convergence help for more informat
2015-07-07 21:06
如图，我学习设计的一个四位抢答器。不知道为什么，图中的函数发生器改成1hz的555振荡器的时候就会仿真失败，提示Transient time point calculation did not converge。学生
2016-04-13 13:19
刚开始接触Multisim，我用的是Multisim14，今天画了一个电路图 实现十进制计数器显示的功能，但仿真是报错 Transient time point calculation did not converg
2016-08-14 20:18
刚开始接触Multisim，我用的是Multisim14，今天画了一个电路图 实现十进制计数器显示的功能，但仿真是报错 Transient time point calculation did not converg
2016-08-14 20:18
[SPICE]transient GMIN stepping at time R3 与 U1-C 都有[SPICE]transient GMIN stepping at tim
2019-09-02 04:37
[SPICE] transient GMIN stepping at time=1.85311e-008[SPICE] transient GMIN stepping at t
2018-05-28 00:13
如上图，环境是orcad 9.2/ capture仿真时报错：ERROR -- Convergence problem in transient bias point calculation
2020-06-16 10:58
[spice]transient GMIN stepping at time=4.54747e-018[spice]transient GMIN stepping at tim
2012-10-09 16:03
老是出现这种错误：[spice] transient GMIN stepping at time =0.000401942，请问怎么解决啊
2014-05-25 14:03
