、测量使能ADXL345_WR_Reg(DATA_FORMAT,0X2B);// 低电平输出中断、16g ADXL345_WR_Reg(INT_ENABLE,0x00);//禁止中断
2019-02-22 12:00
,INT_ENABLE,0x00,GPIOx,Pin_x); //不使用中断ADXL345_Write(SPIx,DATA_FORMAT,0x0B,GPIOx,Pin_x);//全分辨率，右对齐，范围
2019-02-13 07:26
ADXL345_WriteReg(DATA_FORMAT,0x2B); //4位SPI 模式，中断低电平有效，全分辨率，右对齐ADXL345_WriteReg(BW_RATE,0x0A); //采样率
2018-08-10 09:02
ADXL345_WR_Reg(THRESH_ACT,0x01);ADXL345_WR_Reg(ACT_INACT_CTL,0x70); //Ö±Á÷ñîºÏADXL345
2018-09-13 11:33
, 2); x void ADXL345_Ini(void) { ADXL345_write_byte(0x31,0x2B); delayMS(2); ADXL345
2023-12-29 06:46
,0x52); __delay_cycles(2000); Single_Write_ADXL345(0x31,0x2B); //测量范围,正负16g13位模式Single_Write_ADXL345(0x27
2019-03-04 11:48
ADXL345_Ini(void){ADXL345_write_byte(0x31,0x2B);delayMS(2);ADXL345_write_byte(0x1E,
2018-08-01 06:29
刚开始调试ADXL345.用SPI驱动,发送0x00能返回0xE5,但是中断不能触发,XYZ轴寄存器读出都为0.配置代码如下[/td]SpiSend(XL345
2018-09-18 09:59
(0x31,0x0B);//使中断高电平有效Write_345(0x2E,0x60); //使能 SINGLE_TAP DOUBLE_TAP 中断 现象：配置完，main函数直接判断相应引脚电平，用
2018-08-18 07:45
_RD_Reg(DEVICE_ID)==0XE5)//读取器件ID { //=====初始化=====ADXL345_WR_Reg(DATA_FORMAT,0X0B); //低电平中断输出,13位全分辨率,输出数据
2018-10-19 09:28
