is in series using 2 ports of the analyzer and otherwise, I need open, short and load calibration using 1
2018-11-01 11:48
的系数相同）2）将短路的偏移延迟修改为3 * lambda / 8短路的偏移延迟3）修改偏移延迟的开放是lambda / 8的偏移延迟4）更改名称“SHORT”＆amp; “OPEN”至“3/8
2019-02-19 11:14
N9330B机械校准器是否有技术规格？我对LOAD部分的回波损耗规格特别感兴趣，并且是否存在适用于OPEN和SHORT的特定延迟偏移。 以上来自于谷歌翻译 以下为原文
2019-01-28 09:37
SOLT calibration, I connect the short load to one port. The impedance point is not on the short
2018-12-28 15:52
, the Thru is connected correctly though. - Perform a partial cal, re-doing the reflection (Open/Short
2019-09-19 16:37
in an 8720D VNA. When doing the calibration, it asks for an open, short load and thru, but it does
2019-05-31 15:00
TAS5411应用有个问题烦请问一下，Open Load和shorted load两个状态 不更新，open load
2024-09-29 06:56
我使用测试端口电缆的85054D端进行了1端口校准（50MHz至18GHz）和8510C。当我测量另一个85054D calkit Open和Shorts反射系数后，计算得很好的开路和短路多项
2018-09-29 17:26
of the load,open and short as I don't know the response of these standards of the *85052C Calibration Kit
2019-03-01 13:23
, open, load, and finite-length thru that is 1000um - all on wafer. While characterizing the standards
2019-07-25 08:01
