This application note describes how to make an accurate impedance measurement by using OPEN/SHORT/LOAD corre
2019-03-08 17:25
is in series using 2 ports of the analyzer and otherwise, I need open, short and load calibration using 1
2018-11-01 11:48
N9330B机械校准器是否有技术规格？我对LOAD部分的回波损耗规格特别感兴趣，并且是否存在适用于OPEN和SHORT的特定延迟偏移。 以上来自于谷歌翻译 以下为原文
2019-01-28 09:37
的系数相同）2）将短路的偏移延迟修改为3 * lambda / 8短路的偏移延迟3）修改偏移延迟的开放是lambda / 8的偏移延迟4）更改名称“SHORT”＆amp; “OPEN”至“3/8
2019-02-19 11:14
这是AD5765DATASHEET里面关于输出电流的说明 Short-Circuit Current10mA typRISCC = 6 kΩ; see Figure 23 Load
2023-12-21 06:34
in an 8720D VNA. When doing the calibration, it asks for an open, short load and thru, but it does
2019-05-31 15:00
TAS5411应用有个问题烦请问一下，Open Load和shorted load两个状态 不更新，open load
2024-09-29 06:56
, the Thru is connected correctly though. - Perform a partial cal, re-doing the reflection (Open/Short
2019-09-19 16:37
SOLT calibration, I connect the short load to one port. The impedance point is not on the short
2018-12-28 15:52
are always on. I have a N-type short. And with the short on, the S11 and S22 are about the same as open
2018-12-27 16:31
