init_complete位来检查初始化是否已完成。在我发现的所有应用笔记，UG等中，通常只有两个提示，这对我没有帮助： - init_complete是状态寄存器的一部分（UG470将其列为7系列状态寄存器的Bit11
2020-07-30 11:12
我使用ARTIX7固化程序，显示DONE DID NOT GO HIGH，然后DONE引脚外接3.3V上拉电阻，求大神指点该怎么改？大致是什么问题？
2017-04-07 20:56
was not successful. DONE did not go high, please check your configuration setup and mode settings.INFO
2019-05-22 04:35
, I have same problem with Spartan-6 and xcf04 prom.DONE signal did not go high. All other signal (CLK,
2019-06-24 08:05
; SMT1MODE Gated counter; SMT1GO disabled; SMT1CON1 = 0x49; // SMT1CPWUP SMT1CPW1 update complete
2019-07-19 16:01
;go_straight(); percent=high_speed;while(1){if(num_front==3||num_front==9)//DE区减速 {go_straight();percent
2015-06-05 00:09
16F18325 that it has to sample from two different ADC channel at very specific times and quite high
2019-06-03 11:13
high as expected.If I try to write info to the DDR , I can see the DDR control signals go
2018-09-30 11:07
还没有准备好接收数据。 以上来自于百度翻译 以下为原文I found today that if I don't call wiced_transport_init() right away
2018-11-09 15:03
/Init-calib-complete-never-goes-high-using-VC707-Development/m-p/424356#M8802http://www.xilinx.com/support/answers/63463.html和其他几个线程......我的解决方案除了一个之外
2019-10-14 09:27
