“owner-vrf@it.lists.it.agilent.com”。 以上来自于谷歌翻译 以下为原文> I can not change the address of any instrument on GPIB
2019-08-28 09:16
the instrument from the internal windows. The external GPIB is set to 7xx address with a duplicate
2019-03-13 11:38
recognizes that there is something on address 11( also incorrect on GPIB5), which is the tuner controller
2018-12-25 16:17
defaultRM, vi;char buf [256] = {0};/* Open session to GPIB device at address 22 */viOpenDefaultRM
2013-03-07 20:34
- I DO have a seperate address from my laptop Static IP Address for the PROLOGIC GPIB->LAN ETHERNET
2019-05-14 15:33
我在Windows 7上使用ACE试图与E5071C分析器对话，并最终将其集成到我正在编写的c程序中。我已经设法在我的软件和ACE中获得了PNA-L远程GPIB连接。当我尝试连接到ENA类型分析仪
2018-11-02 09:39
the GPIB address it just showed three dashes. Nothing we did could change it back or reset it. Without a
2018-11-29 10:35
using Agilent IO 14.2 on PNA-L N5240A. It has 2 GPIB82350B cards which work on same IRQ address 11
2018-09-13 16:46
本帖最后由 eehome 于 2013-1-5 10:08 编辑 用GPIB/USB接口卡，和GPIB线怎么来连接多台仪器，用一台电脑来控制。和只一台仪器比较有什么要注意的地方，我只会连一台仪器，多台时总出错，我是初学者，指点下小弟吧
2011-06-01 08:45
我安装PCI的GPIB卡并安装驱动后,在资源管理器中不会出现GPIB安装好,而是出现PCI SIMPLE COMMUNICATION CONTROLLER的驱动没有安装的信息. 如果用GPIB-USB就显示
2014-06-28 16:45
